CZH3521 DIE CAST PLINTH FITTING INSTRUCTIONS

1) Drill two 6.5mm holes in the door skin at 55mm centres (N.B. Ensure that the screws will not foul the window mechanism or glass)

2) Locate the plastic grommet bosses fully into the drilled holes ensuring that the grommet is flush with the door skin.

3) Locate the die-cast plinth on the gromrnet and secure using the two coarse threaded self-tapping screws provided.

4) Locate the plastic fixing plate on the plinth and secure using the two fine threaded self-tapping screw's provided.

5) The die-cast assembly is now ready to accept fitment of the ,TEX door mirror, which is secured with the grub screw fitted in the mirror base. (N.B. Do not over tighten the grub screw)

Importation rules regarding vehicles are very specific: Only those over 25 years in age may be brought in to the USA without compilance to Federal Motor Vehicle Safety Standards (FMVSS).