Standard 27.5mm overall length. Very early vehicles had a much longer neck GRC101 AT 33.6mm high.
Grommet 2" at widest point-for the bulk head body elongated hole to protect the heater hoses on cars from 1989 with the in line heater valve and 5/8" heater hose. The 2 hoses go through the baulk head on the left hand side and fits a 32/33.5mm hole. ...
Rubber lower radiator hose for the single point injection cars only-
See C-GRH1242 for an improved Blue silicon lower hose for longer life,better looks, or for hotter climates,there is little price difference for a better qualit...
Front mounted radiators on the twin point use 2 of these on the upper fitting prongs as mounting rubbers. The lower bush is EAP8708
Side mounted for 1990 to 1996 side mounted radiator. UK made with 2 core tubes. V shape fins 20 per inch the BIG Daddy of all rads.
This is a super cool lightweight alloy radiator for 1990 on cars with a 1275 engine which has the overflow pi...
Competition fan belt; for use with large CAM6408 water pump pulley and NO charging system.
Lower radiator hose for the first 1275 minis with HIF38 1.5" carb such as the Ritz sprite and Italian job only from end of 1991 to 1993.
This correct Genuine hose is available at the moment for originality, but an option is to use [link]C-GR...
Genuine rubber plug from Rover to fit on the water pump or cylinder head by pass hose tubes when deleting the hose.For the cylinder head you can fit a blanking plug but the water pump would need changing to GWP187 which has no outlet
This sleeve is used with the 11G227 grommet on all one piece radiator surround top brackets.
These were first used on the one piece cowling from 1974 on. These go on the lower reatining bolt.Sold singly,2 required per car
Fitted in the early 1275cc carb type engines after 1990 before the injection
catalyst. Fits into the thermostat area.
Really usefull adaptor if you want to upgrade your 1/2" heater hose to the later 5/8" bore size used on all later cars.
MAQ10008 same part number.Fitted to 1275cc carb type engines from 1992 to 1994.
Has 2 vacuum pipes conected to it.
Screws into thermostat housing under top rad hose.
Use with special washer MAW10001.
...
Upper radiator bracket fitted from 1990 -1996 on cars with one piece rad cowlings when engines were fitted with a sandwich plate under the thermostat housing which made them taller.
Most minis with dual gauges up to 1969 including Cooper S Mk2 that had oil/temp gauges fitted used this type and all when fitted with a voltage stabiliser.
Minis before Sept 1964 except some super deluxe and pre Sept 1964 Cooper without vol...
Part of our toothed belt drive systems this is the water pump pulley with 28 teeth in alloy for lightness.
The screw that locks the cable on the ADU9102 genuine heater valve bolted to the cylinder head.
This radiator electric fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991 on the last carb models through to the SPI but there was an earler type which is no longer available that was on earlier 1275 coo...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.