This radiator electric fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991 on the last carb models through to the SPI but there was an earler type which is no longer available that was on earlier 1275 coo...
Fitted from 1990 on until twin point cars but also found on some earlier cars with 12G2129 fan blade.
This spacer is: 12mm thick
Known as the 'Hot Climate' or 'Export fan' this metal fan is moves the most air but also absorbs the most power.
The 11 blade plastic fan 12G2129 is quieter and is the most efficient in terms of power absorption and air movemen...
Genuine Rover part from BMH. 11 blade plastic fan, one of the most efficient fans ever fitted to a Mini. This fan pushes a lot of air with very little noise. If you need more air, then please see part# 2A998. This Hot Climate fan pushes ...
FITS INTO SANDWICH PLATE ON CARB COOPER HAS M8 THREAD 8MM WIDE
Single blade. This is our copy of the original special tuning fan blade that we have been selling for nearly 20 years. Many people use 2 of these blades crossed over to make it a four blade fan which does makes it slightly quieter. Sold as single bla...
Used with most of the standard fans, definitely required if you have a breather type timing cover.
This spacer is: 4.05mm thick/0.162"
Plastic electric 10 blade universal 10" sucking type fan unit only-12 volt-for cooling your water temperature. This is also the donor part in our PGG10058MS kit.
This electic radiator fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991. On the 1275 Cooper last carb models there was an earler type fan which is also no longer available. As the original Cooper carb f...
A must for any tuned road car. A full electric fan kit, Mini Spares helped to design with precision made brackets to mount directly to the mini radiator to suck air in order to maximise efficiency and cooling. It therefore does not block cold airflow...
Replacement electric fan assembly complete with laser cut metal brackets so that it can be mounted to the original mounting points of the standard fan
uses 9" blowing air fan.
Similar to C-ARA4401 but supplied without the fan controller. This kit is ideal if you want to wire the fan to a fan switch.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.