From 1996 on twin point injected cars changed the indicator and wiper stalks to accommodate the side/headlamp switch and multi speed wiper plus windscreen wash. Both switches/stalks are now only available seperately.
Replacement headlight switch as fitted to all models from 1976 until 1997.
black cardboard facia trim r/h when 2/3 clock cluster in front of driver. This is the small one with air vent hole
The full rubber style seat diaphragm for early cars 1962-70. This one-piece rubber seating includes mounting clips. Many fit this to later cars as well although a wire strap type CZH3508MS is also available. The clips are also available ...
Most popular of our dashes ,this fits the 3 clock cluster fitted as standard.
Lovely Burr walnut dash for left hand drive cars with 3 clocks in front of driver.
For cars with 3 clock speedo cluster in front of the driver on left hand drive cars this has 3 extra gauge holes cut out.
Trim clip for fitting the stainless/rubber window moulding (EJU10003) on to the door. Sold individually.
Alloy dash for cars with 2 clock pod in front of driver and R/H/D--these dashes have a knob on the glovebox.
MK3 minis introduced a different headlining which was held up by rods rather than the MK1/2 type which were attached to a frame. There are five different colour codes on the 6 rods
number one with red ends is EEB100060
number 2 and ...
This is the diaphragm for the seat squab, the part your back sits against on cars from 1960-92 pre headrest types with twin posts
handbrake handle in Burr walnut to compliment the wooden dashes.
The inside is rough finished and depending on year of car tape will have to be
used on the lever to make this a snug fit.
See also MSA0193 door ...
This kit contains MSA1130/MSA1131/MSA1132 as a car set of TOP QUALITY polished alloy interior door handles.
The interior rear view mirror in the Mini is the most often used in the car, it is also very visible from the outside. The three screw that hold them in place are almost universal regarless of the year of the car. The MK2 mirror only differs in size ...
These pads were used by Rover to help deaden the sound in a mini. Fitted to the door, rear quarter panel and roof panel behind the trim, they stick on.
this is the only steering wheel that will fit the quick release/snap off boss assembly-if you want the standard boss order SWABM--for the snap off boss see SWABS---wheel is 340mm wide(just over 13")
this seal fits on the plastic distribution air box where the rear of the right hand hose fits
Perfectly round gear knob without recess for motif(see BG8114 for motif type)
These knobs get more shiny as they get used owing to your hands unknowingly polishing them everytime you change gear.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.