LIGHT SWITCH MK3 ILLUMIN, currently in short supply use YUF101030
Ashtray that sits in the upper padded dash on all vehicles with 2/3 clocks positioned in front of driver. Early cars had flat plastic tray face whereas later cars had crinkly type face which is the only type available- They all fit the same.
Plain white with black backing aftermarket sun visor as fitted to Mk3 models 1977-92 which were thinner than Mk1 for safety crushing requirements.
Note original colours will fit cars from December 1965. Check out the special clips to hold th...
ALLOY PEDAL PADS, RACE LESS FITTING SCREWS OWING TO USE. 68mm x 58mm
Screw for either end of the material check strap on MK1/2/van/pickup minis with external hinges. The head of this screw is chromed for a superior finish.
Rocker light switch with blade connectors on the back. FITS MK3.
The mini switch with the little green flasher on the end, it was fitted to the MK1 only. The green lens is 47H5200.
Burr walnut wooden dash for cars with 2 clock pods mounted in front of driver for L/H/D cars only
Burr walnut wooden dash for cars with the 3 clock cluster plus 3 extra gauge holes. R/H/D only.
This is Rovers tailor made plastic boot liner which fits all cars with the larger 7.5 gallon petrol tank fitted from about 1974 on. Fits over the spare
wheel giving a very sturdy load floor with a recess for polish or small tools etc. If thi...
The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.
Alloy dash for cars with 3 clock cluster in front of driver and R/H/D.
Most of these dashes now have a knob for opening the passenger side glove pocket so check when ordering if you have specific requirements.
MK3 minis introduced a different headlining which was held up by rods rather than the MK1/2 type which were attached to a frame. There are five different colour codes on the 6 rods
number one with red ends is EEB100060
number 2 and ...
FITS STANDARD 10" AND 12"WHEELS made in strong PVC covered felt known as Hardura
The actual gear lever gaiter screwed to the floor to stop draughs coming up.
for rod change gearbox models only. the metal retainer that screws to the floor to hold this gaiter is FJN10003.
HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.
Rectangular switch for the rear heated screen with pin connectors plus a spade type. 3.1cm tall, from 1976 on.