DASHBOARD ALLOY DASH 3 CLOCK RHD
DASH017

£185.17 exc vat

£222.20 inc vat

In stockIn stock
Alloy dash for cars with 3 clock cluster in front of driver and R/H/D.

Most of these dashes now have a knob for opening the passenger side glove pocket so check when ordering if you have specific requirements.

£185.17 exc vat

£222.20 inc vat

In stockIn stock

Recommended usage 1 x DASH017 to fit one mini.

People also bought products

The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.



Key Features:



Plate is made from powder coated 3mm steel

Spring loaded clamp, hold phones between 59mm to 106...

Printed circuit board for 1989 to 1996 3 clock Nippon Seiko type Mini gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

Original white time clock as fitted by Rover to cars with wooden or metal dashes from 1990-1999. 52mm size Manufactured by Caerbont. From 1999 on the clock manufacturere was changed to VDO with a full numerical figured clock.

2 outer rings and 2 inner knobs which have to be stuck on.

The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

For those wanting an alternative to the Burr walnut colour these black wooden dashes are great. For R/H/D cars only with 3 clock cluster in front of driver.

Late type swith carrier with 4 square holes plus heater and choke cable holes-uses the ratchet type choke cable with D shape fitting--earlier cars used round hole for pull and push chooke cableCZH3591

Mk1 style alloy gear knob. Will suit any Mini standatd gear lever thread.

Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...

Special shaped overmats for your Mini with our Mini Spare logo--one of our bset sellers. Overmats with Mini and Mini Cooper on are no longer available as BMW own the copyright and stopped our manufacture afer 15 years.

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

The rubber type grip fitted on handbrakes-

will fit any single cable hand brake from 1976 on

Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...

Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.

Rectangular grey plastic with white plastic interior lamp was fitted to minis from 1974 until 1985. 4.25" long and 1.75" wide. From 1984 on Rover recessed the lamp AFU4092 into the headlining. Fitted with GLB239 bulb. The le...

Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.

Metal plate switch carrier for 5 square type switches.