Mini Spares Articles - Fitting Guide for DAM100690MS GB BADGE in Stainless Steel

The badge is pre-shaped to allow easy and permanent fitting to boot lids.

This badge fixes to the body by the double sided tape attached to each letter and the area where they are to be fixed MUST be cleansed of all polish, wax or road grime by using T Cut or any suitable chemical. Peel off the outer protective tape coating and then firmly place in desired position. You can then polish around the badge to retain the ideal sheen. Failure to clean the fitting area first will result in poor adhesion.

17/12/2005

The badge is pre-shaped to allow easy and permanent fitting to boot lids.

This badge fixes to the body by the double sided tape attached to each letter and the area where they are to be fixed MUST be cleansed of all polish, wax or road grime by using T Cut or any suitable chemical. Peel off the outer protective tape coating and then firmly place in desired position. You can then polish around the badge to retain the ideal sheen. Failure to clean the fitting area first will result in poor adhesion.

Importation rules regarding vehicles are very specific: Only those over 25 years in age may be brought in to the USA without compilance to Federal Motor Vehicle Safety Standards (FMVSS).

Author

admin