This rubber boot covers the indicator/turn signal housing inside the fender. Fits the Mini and it's the same front & rear for the Bugeye sprite and various other British cars.

This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.

gasket between lens and lamp unit on Clubman front lamp

Lucas clear upper lens for cars with reverse lamp built in rear lamp

with correct bulbs for the fashionable clear rear lens look. If you want to replace the lower clear lens with the red reflector because they are faded or damaged use kit MS...

White lens kit 1988 on. If your front indicator lens is held on by screws then this is the kit for your car with the side wing repeater lens also and correct orange bulbs.

If your front lens is held on by the chrome retaining ring as per all...

The front turn signals have an easy to replace chrome ring but this is in stainless steel. Designed for CHM13 lamps with the plastic lens, it will need filing out to fit the glass lens units.Sold singly, 2 required per car.

A favourite consumable goods item used for many purposes using no 10 screw, also fits early rad cowlings that use ARA1117 screws.

Plastic bulb holder for the wing side mounted flasher on cars from 1986 on--

make sure you change the seal AFU3112 when you dismantle these to stop water corrosion. sold singly, 2 per car required.

This is the white lens kit for cars that have side repeater lens on the wing and earlier indicator lens that were held in by the chrome ring. Pre MSSK28 type

for about 1 year from 85-86 during cross over period where front indicator lamp the...

This is the side repeater lamp that first appeared on the Mini Special in 1989

and on some special edition minis and the ADO16 model Austin, Morris and MG 1100/1300. The later 1986 cars had the square lamp PRC9916A fitted.

The outer white lens is the same as used on the conversion of the orange type used on 1986-1996 cars but the body was different on twin point cars and used a safety plug. The white lens if broken is moulded in the body but can be cleaned out complete...