MIRROR HEAD TAPERED COLLAR WHITE
47H9649WHITE

£2.99 exc vat

£3.59 inc vat

In stockIn stock
Alternative Collar for the WHITE mirror but with a TAPERED shape as opposed to the white rounded type as fitted to complete mirror 24A2110

The Light grey plastic 6" mirror was fitted from 1964 - 1970.white 1970 on

The first 6" light grey plastic mirror with a twin ball stem and black sucker was patented in 1962 and first fitted in October 1964. The twin ball stem was replaced with a 3 ball stem 24A2111 which had the extra ball on the stem centre where a new clear plastic sucker CRT10004 was attached.The early black sucker was fitted to cars with sun visors that had a hinge at one end and a clip at the other.

When they introduced the sun visor with hinges at both ends in 1965 they started fitting the 3 ball mirror stem shortly afterwards.

The white mirror was introduced on production cars from MK3 1970 on but seems to be found on some earlier cars although many look white when blemished by the sun.

It is only when you look behind the glass of the mirror or inside of foot where it attaches the body the true colour can be seen. Most Rover aftermarket mirrors were sold as grey-see 24A1750 but both white and grey 6" mirrors appeared under this part number by Rover and then winguard made a 7.25" mirror

in white to confuse all..Most Mk1 and Mk2 had grey 6" wide mirrors

£2.99 exc vat

£3.59 inc vat

In stockIn stock

Recommended usage 1 x 47H9649WHITE to fit one mini.

Alternative products

Collar for the mirror in grey with a rounded shape as opposed to the grey pointed type as fitted to complete mirror 24A1750

The Light grey plastic 6" mirror as fitted from 1964 - 1970.

The first 6" light grey plastic m...

People also bought products

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.

plastic heater knob that pushes on the end of the control lever on Mk1/2 heaters. one required per car.

Wiper mounting kit for Mk1 Mini's (3 required per car). Each kit comes with a pin, nut, 2 washers and mounting rubber.

Sun visor side clip for cars from 1964-5 with first plastic type rear view mirror and black sucker. The visor had one arm held in another plastic clip on the front which is GFK7344

Gasket for the chrome base CZH3521 to door as fitted to factory production cars from 1970 -80.

The fixing holes to door are 2.1/8"(55mm)centres apart where as late cars are only 3/4" apart.

Stainless steel version of CZG5254 door striker plate. These used to be sided on earlier models but now fit either side. CZH627 striker plate lock with a loop fits into this. Supplied in pairs with stainless steel fixing scr...

This is the guide plate for the bonnet locking pin, now in stainless steel.

White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...

Blank plate on bulkhead with no holes for heater hoses

ALA7530 with 2 holes

ALA6592 with one hole

ALA6593 with no holes

Collar for the mirror in grey with a rounded shape as opposed to the grey pointed type as fitted to complete mirror 24A1750

The Light grey plastic 6" mirror as fitted from 1964 - 1970.

The first 6" light grey plastic m...

One pair (saloon car set) of rear quarter door cards in black , 1976 - 1980

The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.

Light grey plastic 6" mirror fitted by BMC as standard from October 1964-69.

The first light grey plastic 6" mirror with a twin ball stem and black sucker was patented in 1962 but not fitted until October 1964. At the end of 1965 the twin ba...

White plastic 6" mirror as fitted by Leyland from Late 1970-75.

Also found intermittently on earlier cars but original grey fades into white.

The first 6" light grey plastic mirrors was patented in 1962 but were first fitted from Oc...

Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...