HANDBRAKE GAITER GENUINE ROVER
FJM1000010PMA

£24.00 exc vat

£28.80 inc vat

Out of stockOut of stock
Vinyl handbarke lever cover with internal tie clip at lever end and on the floor end has a locating tag. A good preformed shape as fitted to MPI--the last few available and CK989 will have to be used

£24.00 exc vat

£28.80 inc vat

Out of stockOut of stock

Alternative products

This trimming gaiter is for better looks.

If you are looking for the gear lever rubber gaiter that stops draughts you require 14A6860 for magic wand, 22A608 for remote and CZH4278 for rod change.

People also bought products

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.

When wooden dashes are fitted this is the short hose required to fit between the dash and vent connector for fresh air vent units, 4"(100mm) long with 2.75"(70mm) internal diameter.

This 10 piece handle set is exactly the same kit as sold by every other mini specialist is in bright alloy (not polished alloy as per our other superior kit MSA1129) and consists of two of each of the following, door openers, window winders and their...

White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...