£129.05 exc vat
£154.86 inc vat
In stock
the rods are
red end x1 EEB100060
white ends x2 EEB100070
black ends x1 EEB100080
blue ends x1 EEB100090
yellow ends x1 EEB100100 side sections between the rear side window and backlight.
£129.05 exc vat
£154.86 inc vat
In stockRecommended usage 1 x HL3014P to fit one mini.
Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...
Mini Pickups had a one piece headlining frame with the canopy glued and stapled to it. Cream Crackle was used on early models and the light grey was used during the 1970's. These frames are no longer available, so make sure you keep the frame safe if...
Headlining kit including C post trims in cream crackle for 67-69 Minis which have a larger rear screen.
Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...
Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow
number 1 with red ends is EEB100060
number 2 and 3 is white ends are both EEB100070
number 4 with black ends is EEB100080
...
Black sun visor less mirror that requires clips both ends but never a standard fitment colour fits cars from Dec 1965. Available as a sought after alternative to the cream colour. The brackets are available as a car set only(4 clips) as SV20...
These headlinings are held in by different shape/length rods which are NOT included but we do include the rear corner side sections between the rear side window and backlight which many poor copies do not
the rods are
red end x1...
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
The rubber type grip fitted on handbrakes-
will fit any single cable hand brake from 1976 on
Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
Original BMC stick on logo for use on gearlever knobs and key fobs sold by us.
about 27.4mm wide
Fitted 1969-77 and 1992-96 originally and white from 1970-96 so see PAM5401BLACK and PAM5401AP. C posts trims changed with MPI or Heritage shells.
These headlinings are held in by different shape/length rods which a...
This is the top of the range spray glue that is used to make all our trim products. We recommend you use spray glue to fit your trim products to your car (where applicable). You can use the glue to fit underfelt and carpets to your floor pan, your fo...
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
Union Jack stick on logo for use on gearlever knobs and key fobs sold by us.
About 27.4mm wide.
GT emblem stick on logo for use on gearlever knobs and key fobs sold by us.
about 27.4mm wide, please note these are now black and silver not black and gold.
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Fire retardent felt with correct cut outs for MK3 cars for the mini firewall just behind the carb and air cleaner full width of the panel see FELT860 for spray adhesive.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.