Competition type 4 point harness wth 2" wide straps and for colours see

MSA1110 for black and MSA1110RED --for 3" wide strap see C-SSB1000/2

Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...

With headrest-this fixed back traditional bucket seat is the entry level

version of Cobra seats and has dep sides and a low back to ensure comfort and support without the restrictions of a larger seat. Black vinyl and no piping-

Fixed back for fast road this is Cobras New Clubman seat which still represents

good value with its massive leap in quality and design. Integral headpad and shoulder supports,deep sided bucketed supports,integral lumber support and four poin...

FIA certified and approved for motorsport it is lightweight and has compact styling. Slotted for use with competition seatbelts and the ultra strong construction has reinforced shoulder and side pads. In black, now comes with mountings for use with s...

MK3 Black Mini door and rear quarter trim(4 piece kit) in vinyl as per original twin line pattern per Mini and CooperS but for cars after May 1973 where the rear quarter panel trim shape did not have a cut out for the ash tray mount and if you look a...

Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...

Printed circuit board for pre 1989 cars with Smith's 2 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

Although not FIA approved this is made by the top roll bar company Safety Devises. Do not get caught out buying cheap inferior types of unknown quality.

Comes in Black.

127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.

This red carpet is the correct moulded shape with insualation material attached where appropiate for that smart fit over the gearbox tunnels etc.For vehicles pre 1972 with remote or magic wand type gear levers you will therefore have to cut this hole...