Reinforced elastomer liner for door trim made from VELVEX to prolong the life of your door cards.Die cut on press tools that make the original door cards. Each hole for door locks, window winders, door handles, speaker holes are precision cut to fit ...

Vinyl covered 9 piece red interior trim kit

This kit is for wind up window type doors,for MK3 saloons with inertia seat belts from 1974 onwards and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rea...

Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

Metal plate switch carrier for 5 square type switches.

Uses ADU8081 screw and YXX3200PA cover. With a spring loasded winder knob this handle was fitted to later cars as a safety requirement. Fitment was from 1983 but fully introduced in 1984

Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.

2 outer rings and 2 inner knobs which have to be stuck on.

Fire retardent felt with correct cut outs for MK3 cars for the mini firewall just behind the carb and air cleaner full width of the panel see FELT860 for spray adhesive.

High quality, these polished door opening handles will fit all models with windup windows.

For matching window winders see MSA1130.

See MSA1129 for complete car set

This plastic clip was commonly used by Rover for all car trimming and first found its way on the wind up window version mini door panel.9 per side but always purchase a spare in case of breakages.