($25.50) £25.50 exc vat
($30.60) £30.60 inc vat
In stock
complete car set
($25.50) £25.50 exc vat
($30.60) £30.60 inc vat
In stockRecommended usage 1 x CHM73 to fit one mini.
If you still have a lovely 1275GT Clubman these are the original type of stripes that go along the bottom. This is a complete car kit.
If you still have a lovely 1275GT Clubman these are the original stripes that go along the bottom. This is a complete car kit.
Roof gutter trim clip in stainless steel, ideal finishing item for our MT632 roof gutter trim.
Aftermarket decal kit for British Open Classic models. Kit includes 2 rear quarter decals, 1 bootlid decal and pinstripes.
These Mirrors are made in the UK by Tex. Slightly convex lens gives excellent rearward visibility. Left side. Right is GAM217. For fitment to laters cars originally fitted with plastic mirrors, use fitting kit M90997. See also
G...
The Mini's roof begs to have a British flag on it! This kit is made of pre-cut vinyl and can be applied by anyone! This is a genuine Rover accessory. The colours blue and red are called pop art design because Rover were not allowed by law to use th...
A full set of four arches and two side trims as fitted to all factory cars from 1984 on as standard fitment. Kit includes set of black screws although some were originally held on by pop rivets ADU8629
Original BMC rosette transfer sticker for the outside of you car on panel work etc.
These are water transfers, soak the item in water until the decal slides from the backing, slide onto your work peice and carefully squeeze out wat...
Special Tuning Abingdon decal is green on white vinyl.
Black Plastic Fluted Strip, runs between the 2 plastic Mini Special Arches. Fitted as standard from 1984 to 1992. Approximately 1270mm long.
Screw on black plastic wheel arch as fitted to factory specials plus innocentis and all minis from 1984 on until the sportspac arch. The grey type fitted to Mayfairs are no longer available. This is the Right hand rear and ready to screw on.
Classic Mini trademark badge for classic mini winged badge about 42mm wide with the correct dome shape. This is a replacement for DTC100680MNH cap as well as
DAH100590MMM.
Vehicle centre caps and winged bonnet...
Quality Aftermarket Body Seam Covers. These are the vertical ones that protect the 4 corners of your cars body seams. Both original and Mini Spares own aftermarket strips are available plus a stainless steel version for that special Mini.
Mini Spares/Tex stainless steel/chrome door mirror from Tex were fitted to production minis from 1970 to 1980. These large 3" x 5.5" mirrors have also been used on many later models of the Mini, they look good and allow you to look great (rearwards) ...
These Mirrors are made in the U.K. by Tex. Slightly convex lens gives excellent rearward visibility. Right side, left is GAM218A. For fitment to laters cars originally fitted with plastic mirrors, use fitting kit M90999.
See als...
Black bushes for wiper wheelboxes. Sold as a wiper wheel box set(one above the windscreen scuttle cowl and one under the cowl), takes two sets per car.
To fit early Mk1/2 cars cut down the part that fits under the panel work part(this part h...
The blue and silver square British leyland badge that sticks to the A panel on cars circa 1970. Early cars had a prong fitting but it was replaced by this stick on type and found its way on many cars.
Minispares original design and concept, many people have copied these but poorly, as ours are in stainless steel with nut fittings so they seal properly and cannot be stolen .If cleaned regularly they will stay smart and bright for a lifetime. Sold ...
Finishing clip in brightwork (chrome colour)for 24A1466MS locking strip in windscreen and backlight rubbers.
8 sided nut for the Mk3 wiper wheel box (37H7200)from 1970 Mk1 were 6 sided and a different thread. Also fitted 1275 sprite and MG Midget with round body wiper motor.Sold singly 2 required per car
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.