($232.45) £232.45 exc vat
($278.94) £278.94 inc vat
($232.45) £232.45 exc vat
($278.94) £278.94 inc vat
This 4 piece set will fit all Travellers and Estates built before 1966 with an external petrol tank(1961 on). The kit contains a piece of carpet to fit the rear of the back seat and another piece to cover the rear floor area plus 2 side pieces. For t...
Moulded biscuit colour carpet set for Rod change change with sound proofing attached where appropiate.
These fit correctly and snugly in your car over the tunnels etc for that professional look.2 rubber front foot pads and on rear carpet has...
Interior lamp with a black on/off switch and pointed torpedo ends.
Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.
Also there was an alternative lamp with black switch and square ends 13H192 which w...
This is a 2 piece headlining for mini travellers, for the later Clubman 2 piece headlining see part number HL3022
'Walnut Burr gear lever knob.
Standing 3.5 inches tall with a shape that is comfortable to the hand it really makes a statement. the old original type with a logo has been made obsolete owing to royalty and intellectual agreements held by Ro...
MK1/2 style pattern door and rear quarter black vinyl trim kit for MK3 on
These are the 4 major parts that can give your car a fresh look- only fits wind up window type doors as fitted to MK3 range mid 1973 on , without ash tray facility in...
Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
Reproductions of the original black knob with engraved white shift pattern, complete with anti-vibration rubber insert.
Magic Wand rubber shift boot.
The first Minis had a very simple gearchange, the lever exits the transmission directly through the floor. This requires a special boot to accommodate the curves in the floor and tunnel and being rubber it event...
Burr walnut wooden dash for cars with 2 clock pods mounted in front of driver for L/H/D cars only
handbrake handle in Burr walnut to compliment the wooden dashes.
The inside is rough finished and depending on year of car tape will have to be
used on the lever to make this a snug fit.
See also MSA0193 door ...
The full rubber style seat diaphragm for early cars 1962-70. This one-piece rubber seating includes mounting clips. Many fit this to later cars as well although a wire strap type CZH3508MS is also available. The clips are also available ...