($111.00) £111.00 exc vat
($133.20) £133.20 inc vat
In stock
($111.00) £111.00 exc vat
($133.20) £133.20 inc vat
In stockRecommended usage 1 x 88G487 to fit one mini.
For the rear opening type quarter light, glass only in clear, MK3 ON.
MK3 DOOR WINDOW GLASS.
IF A MAIL ORDER OR INTERNET ORDER IS PLACED FOR THIS ITEM IT IS AT YOUR (THE CUSTOMERS) LIABILITY, WITH REGARDS TO DAMAGES.
Clear laminated windscreen for all minis except Twin point injection cars 1996
on which had a special screen with built in interior mirror base.
IF A MAIL ORDER OR INTERNET ORDER IS PLACED FOR THIS ITEM IT IS AT YOUR (THE CUSTOMERS)...
Front door sliding type front window glass. MK1/2 plus all mini commercial type derivatives
The black windsreen and backlight rubber fillet. Chrome is more popular however.
A single length for a single screen is 37H8052
This flat rubber seal can be use for opening rear 1/4 windows or radiator to inner wing. Supplied in 2 metre lengths. 38mm wide.
can also be used on the petrol tank straps and plinths
Genuine Mini Spares mouldings product as supplied to Rover.
These are the later door mouldings that prevent water running down the windows into the door causing rust and have the black platic ends fitted for later car safety regulations but ...
Genuine Mini Spares product as originally made by Pianoforte and then Mini Spares for Rover.Clips for this are EYC10048
This is the 1/2" tall thinner type fited to wind up window cars from 1970 on.
The original 1" talle...
Genuine MK3 wind-up window upper slide up and down felt lined channel that fits into the R/H upper door frame. Left (PAM3077) and right (PAM3076) look identical but are mirror images.
Genuine MK3 wind-up window upper slide up and down felt lined channel that fits into the upper door frame. Left (PAM3077) and right (PAM3076) look identical but are mirror images.If you are looking for a cheaper budget version see PAM3077MS
...
Rubber seal for all mini windshields. Uses locking strip 24A1466(chrome) or 37H8052(black.) REMEMBER YOU MUST FIT THE RUBBER TO THE BODY FIRST. DO NOT USE THE STRING METHOD BECAUSE IT STRETCHES AND TEARS THE RUBBER.
There is a later wider r...
Most minis have a chrome coloured plastic insert in the windscreen rubber but
some owners in hot countries prefer this black one, which some claim is less prone to shrink or go off colour.
Finishing clip in brightwork (chrome colour)for 24A1466MS locking strip in windscreen and backlight rubbers.
The MK1/MK2 Mini not only has a smaller rear side quarter window than the MK3 but also the rubber seal is cosmetically different. The only seal available for years was the MK3 which has a grain texture on the inside edge. Now in stock are very good r...
Draft excluder for sliding window doors as fitted to Mk1/2 Minis. Right hand side. Properly cut angles as original.Either crimp both ends with your fingers to make it stay on door glass or use a glue as per the factory on later vans.
Qty one...
Genuine Mini Spares quality product. For Mk1 cars use 14A8744
For Pickups you will need to cut and shorten either seal and make sure the join is at the bottom. The extrusion is the correct shape.
This seal is the best ...
Genuine Mini Spares mouldings product as supplied to Rover.
For wind up window cars 1970 on this is a set of inner and outer door brightwork mouldings with rubber seals attached to stop water running down the windows causing rust and to prev...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.