($92.40) £92.40 exc vat
($110.88) £110.88 inc vat
In stock
The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon.
In crackle black finish.
Attaches to top and bottom parcel shelf rails either side...
($92.40) £92.40 exc vat
($110.88) £110.88 inc vat
In stockRecommended usage 1 x C-AJJ3331 to fit one mini.
Headlining kit including C post trims in cream crackle for 67-69 Minis which have a larger rear screen.
Cream with crackle finish sun visor fitted as standard from December 1965-69 but will fit Mk3 on if required. With mirror for passenger side. For a car set of clips see SV2021
Mk1/2 1965 on cream crackle SV2017C
Mk3 196...
Cream colour crackle finish sun visor as fitted from december 1965 onwards. Will fit later cars if required. Drivers side without mirror.Check out the special clips to hold these visors as they are sold seperately in car sets only as SV2021<...
Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...
Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow
number 1 with red ends is EEB100060
number 2 and 3 is white ends are both EEB100070
number 4 with black ends is EEB100080
...
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
Original Autin emblem stick on logo for use on gearlever knobs and key fobs sold by us. About 27.4mm wide.
Original BMC stick on logo for use on gearlever knobs and key fobs sold by us.
about 27.4mm wide
Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...
Vinyl covered 9 piece black interior trim kit
This kit is for wind up window type doors,for MK3 saloons 1973 onwards (except Cooper S) and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rear wheel a...
Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.
See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...
A bit larger than the MK1 to accept the improved indicator switch this fitted
MK2 and MK3 cars until the introduction of the steering locks.
Even if you have not just restored your car- you don't want the door to fly open uncontrolled. Not only can it damage the hinges but also the paint job.
Check straps matched seat colours or outer main seat colour on two tone types
(...
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.