£89.37 exc vat
£107.24 inc vat
In stock
£89.37 exc vat
£107.24 inc vat
In stockRecommended usage 1 x 56-9265 to fit one mini.
This clip fits on the pedal to help retain the throttle cable-
It was obsolete but the spring on the carb end keeps it from sliding out anyway. Probably just a security feature on HS4 carbs at the time.
Stainless steel polished locking cap for all post 1970 cars-non vented.
Comes with 2 keys.
Fuel tank sender unit for saloons up from 1964 to 1992 when a voltage stabiliser was fitted.1964 built cars could have had a similar locking ring type but if no voltage stabiliser fitted on back of speedo they fitted a ARA959 which is ob...
Ideal well priced electric fuel pump for replacing either electric or mechanical pumps when using single HS or HS2 twin carbs 4.00-5.5 PSI delivering 18 gallons per hour.
Other parts required to fit this pump are:
FPA9...
Pumping 40 gallons per hour this is ideal for big bore/stroked engines with twin choke or split carbs over 45mm choke size and will require 5/16" fuel lines
Seal for Saloon petrol tank sender unit and the retainer clip is ARA1501. Early type tanks had 6 screws holding the sender unit in place and the gasket is GUG705711GM. .
5" long steel intake manifold by Maniflow for Weber 45 DCOE/DHLA.
this rubber mounting kit helps to dampen the pump ticking noise as well as acting as an earth
Flat racing type cap with large opening catch in chrome with collar
To fit the collar for this cap you will require 10mm(0.3937")just over 3/8" of petrol tank neck accessable above the body seal to allow fitment, many later cars do not have ...
Mechanical fuel pump, pre1990 driven off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad as often raw fuel is pumped into the engine. This dilutes the oil and causes severe we...
Paper gasket for either side of the spacer on all mechanical fuel pumps fitted on the rear of engines. The spacer with gaskets fitted is available as GUG705603GM.
The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.
These Swedish made Misab plates are known as the best for mounting your 40/45DCOE carb to its manifold to avoid fuelling problems. Sold singly per gasket
Fits in place of the oil pick up retainer plate on the back of the gearbox this magnetic plug with filter collects metal debris from going back into the power unit but should be regularly cleaned. A non filter type of theis version is available as [l...
Universal crank case breather with chrome top and a 13mm(1/2")neck size.
2"wide top (50mm) and 35mm high
Non Genuine petrol tank neck seal, we advise fitting 14A7057GENUINE for extra longevity, quality, looks and a much better fit where we seem to be the only company offering a quality part, from our own tooling made in the UK.
Thi...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.