£19.50 exc vat
£23.40 inc vat
now
£16.58 exc vat
£19.90 inc vat
In stock
£19.50 exc vat
£23.40 inc vat
now
£16.58 exc vat
£19.90 inc vat
In stockRecommended usage 1 x ALA5686 to fit one mini.
Genuine MK3 onwards inner wing boxing plate for the LH side.
R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3
this is a genuine heritage part.
THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
This panel is for wind up window type doors that have internal hinges and this contains the part of the front A post where the hinge and door stay holes are down to and including the door step and along and up the B post a few inches covering the mai...
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.
Upgraded R/H "A" panel for all Minis with internal hinges,1970 on.
A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.
Only available from Mini Spares th...
This rear bulkhead panel is the actual panel the rear passengers back rest against where the upright seat squab is positioned. Not always carried in stock but usually available to special order--this is done to the last factory pressing with the loca...
1970 on, cars with internal hinges and wind up windows
This repair R/H panel has holes for the hinges on A post and overlaps 6" at top tapering to 9" at bottom (150mm-215mm) onto the wheel arch section.
Also has the first section of...
Closing plate against the bodyside in the base of the l/h rear companion/glove box now has a square pressing hole for later models
closing plate against the bodyside in the base of the r/h rear companion/glove box now has a square pressing hole for later models
These door step panels actually have the start of the curves at the end where they are able to rust and therefore better than the straight sections that these replaced. This is the right hand side, see MS16L for left hand.
These...
MK3 door hinge fitting kit for all internal hinged doors. (hinges not included)
4 Non Genuine door hinges as a car set for wind up window type doors from 1970 on. These are a top quality item as opposed to the cheaper junk version available on the market.
Sold seperately as
top right CZH202MS 1 r...
non genuine R/H outer MK3 door skin.
not as good a fit or looking as the genuine CZH3301 but a good inexpensive replacement less mirror holes
This is the boot seal that actually fits on the car body which saved drilling holes in the bootlid. Fitted from about 1988 on.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.