£92.40 exc vat
£110.88 inc vat
In stock
The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon. Often seen in car magazines and competetion rally books.
Attaches to top and bottom parcel shelf r...
£92.40 exc vat
£110.88 inc vat
In stockRecommended usage 1 x C-AJJ3330 to fit one mini.
Plain white with white backing aftermarket sun visor as fitted to Mk3 models 1977-92 which were thinner than Mk1 for safety crushing requirements. Although not standard for earlier models will fit cars from December 1965. Check out the special clips ...
door cappings in carbon fibre to compliment carbon fibre finished dash
Similar to those fitted as standard on the late Coopers this piece of trimming is purely cosmetic although it may help to eradicate some road noise that might get past the standard rubber gaiter--This is black with red stitching.
This chromed bracket is to secure the early Mini sunvisor with the central location.
1959-64 visors had one central hinge and in October 1964-65 they fitted a sunvisor with a hinge one end and clip fixing the other-this is when the first pla...
This was the first style of sunvisor pad with central pivot point in cream crackle finish used on the early Minis.Some very early minis used pale grey for std but all Supers had crinkle finish cream to match headling. For this period the Cream Crackl...
High quality, polished alloy door pull handles.
These aluminum handles will wind up window cars and they won't snap off like the original plastic ones
For matching window winders see MSA1130.
See MSA1129 for...
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
The metal retainer that holds the rod change gear lever gaiter CZH4278 in place
Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.
See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...
A bit larger than the MK1 to accept the improved indicator switch this fitted
MK2 and MK3 cars until the introduction of the steering locks.
Even if you have not just restored your car- you don't want the door to fly open uncontrolled. Not only can it damage the hinges but also the paint job.
Check straps matched seat colours or outer main seat colour on two tone types
(...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.