£81.75 exc vat
£98.10 inc vat
In stock
£81.75 exc vat
£98.10 inc vat
In stockRecommended usage 1 x C-ARA339RB to fit one mini.
Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.
The long wheel base of the Mini Van, Wagon and Pick-up means the popular RC-40 exhaust comes up a little short! This system from Maniflow (pipes, resonator and muffler), is made for the long bodies. Just because you have a utility vehicle it does no...
For all cars with a catalyst--this section fits from the catalyst back and has 2 silencer boxes.1.75" bore
Standard bore road LCB (1-3/4"id) that has an enlarged and reshaped middle pipe which creates a type of vortex, simulating a pulsing effect similar to the outside two pipes,thus producing an improved BHP,Torque and power curve.Ideal for very hot smal...
Exhaust manifold to downpipe clamp. For 32mm o/d pipe size.
The key to eliminating exhaust leaks at the manifold flange is the clamp. These cast clamps are the best style to use. A real piece of kit to use eradicating a multitude of likely p...
The center exhaust hanger takes a lot of abuse during hard acceleration or if you're low enough to bottom out on bumps. This mount has a through metal bolt to keep it intact.
Special tin plate type of gasket that goes between the manifold and exhaust downpipes on all injection cars.
Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG
Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.
these bolt onbrackets were made to fit on the rear subframe when fitting the later type rubber hanging strap exhausts. this one fits on the front of the rear subframe.
cars from about 1991 on had these brackets welded in position
Metal gasket for the catalyst and is the same both ends for Cooper 1275CC RSP early cars, but only fitted on the front to later cars. If you cannot fit this gasket on the rear your car does not need one.
The original replacement is expensive so when it needs replacing many customers
opt for our stage one kit C-STN22 which gives extra power for litle more cost.
in this kit you will get an exhaust manifold, which is bette...
Twin box exhaust system for all 850/998/1100 saloons
Now designed by our RC40 team as a 2 piece system for easier fitment and transportation, this fits from the original cast iron inlet/exhaust manifold
right to the rea...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.