£1.00 exc vat
£1.20 inc vat
Out of stock
£1.00 exc vat
£1.20 inc vat
Out of stock
Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)
Moulded shape type right hand door stay grommet fitted until 1985 when it was replaced by a flat sponge type seal CGE10038/9.
Fitted to inner wing 1990 on, plus on a bracket on the rear wheel arch in boot area for all single points onwards. For earlier cars where fitted on the bulk head you may need to put a spacer behind to make removal of bottle easier.
Original ...
Moulded shape type left hand door stay grommet fitted until 1985 when it was replaced by a flat sponge type seal CGE10038/9.
Quality Aftermarket Body Seam Covers. These are the vertical ones that protect the 4 corners of your cars body seams. Both original and Mini Spares own aftermarket strips are available plus a stainless steel version for that special Mini.
Zinc plated mild steel clip for fixing vertical seam mouldings to the body.
The pin that goes into the door stay check arm on the door itself on all minis with wind up type windows from 1970 to 2000.
Genuine door check strap for MK3 cars with wind up window doors.(use with retaining pin CLZ412 ). Beware! there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly.
Grommet 2" at widest point-for the bulk head body elongated hole to protect the heater hoses on cars from 1989 with the in line heater valve and 5/8" heater hose. The 2 hoses go through the baulk head on the left hand side and fits a 32/33.5mm hole. ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.