£4.80 exc vat
£5.76 inc vat
In stock
Original 1970 on bracket CZH1624 was shaped to push bottle away from bulk head
in a more upright position.
£4.80 exc vat
£5.76 inc vat
In stockRecommended usage 1 x CZG1496 to fit one mini.
Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.
Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.
Non genuine R/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a complete inner sill replacement panel. With carpet fix brackets.
Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.
Front A panel part of door frame for internal hinge cars Left hand.Non gen
Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
L/H narrow 6 flute outer sill for mk3 saloons to 2000 but most 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel
Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.
For Mk3 but can be used as a part of repair sectiion for Mk1/2
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
part inner wing R/H from Damper bracket mounting points forward MK2/3 except Clubman. 1969-91 not Mk1/2 as it has air hole in side
NON genuine panel
Non genuine L/H repair section
for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...
Aftermarket version of the L/H floorpan for 1991 on cars.
This floor was made stronger with smaller heel pad area to prevent vibration and rust and will fit any Rod change gear shift mini but was introduced on the first injection cars in 199...
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...
genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.