FRONT FLOOR PAN L/H PRESHAPED
MS25L

£33.00 exc vat

£39.60 inc vat

In stockIn stock
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include the side of the tunnel on rod change cars. Just trim this extra material off for pre 1973 round tunnel floors.

A true full MK1/2 floor pressing is available for the purists as [link]FS006L[/link] or [link]MSL25L/link] for front section 1990 on.

This was fitted up to 1990 when they put a strengthening rib through the centre of the floor to carry pipes such as fuel lines on the single point.

£33.00 exc vat

£39.60 inc vat

In stockIn stock

Recommended usage 1 x MS25L to fit one mini.
Van, Estate and Pick up Floor - Qty 1
Saloon Floor Panels - Qty 1

Recommended products

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...

Alternative products

floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...

People also bought products

Blanking plate for covering the magic wand gear lever hole.

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Rear handbrake bracket. 1976 onwards for single cable lever. Welds to tunnel. Not included on CZH2669 floor. For forward bracket see CZH3214.

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.

The top rear capping panel is also available as 14A7558CAP

Non Genuine R/H lamp repair panel for rear corner panel on the Mini Pick-Up.

The top rear capping panel is also available as 14A7557CAP

Although this panel is non genuine it is the most accurate for MK1 Cooper S restorations as it has the correct number plate brackets and slam panel.

If you have a pre 1964 car with the one piece valance with no cooling cut outs for brakes ...

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Repair section of bottom of door for external hinge cars, MK1/2.

This crude non genuine parts is the only repair section available for early doors apart from door skins.Lots of stretch marks and wrinkles but they have been fitted by customer...

Repair section of bottom of R/H door for external hinge cars, MK1/2.

this crude non genuine parts is the only repair section available for early doors apart from door skins. Lots of stretch marks and wrinkles but they have been fitted by cus...

Non genuine R/H Van inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. For Mk1 VAN

Non genuine L/H Van inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. For Mk1 VAN

non genuine L/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skinCZH3301

non genuine R/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skin CZH3301

Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.

Non genuine R/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a complete inner sill replacement panel. With carpet fix brackets.

Non genuine section repair panels equivalent to MS51VAN. This is the left hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material

Non genuine section repair panels equivalent to MS51VAN. This is the right hand side with castellated nut fittings for subframe

For vans with metal load floors and pickups so match up before cutting out to much material