£7.20 exc vat
£8.64 inc vat
In stock
£7.20 exc vat
£8.64 inc vat
In stockRecommended usage 1 x CZH1624 to fit one mini.
Fitted to inner wing 1990 on, plus on a bracket on the rear wheel arch in boot area for all single points onwards. For earlier cars where fitted on the bulk head you may need to put a spacer behind to make removal of bottle easier.
Original ...
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
Reinforced elastomer liner for door trim made from VELVEX to prolong the life of your door cards.Die cut on press tools that make the original door cards. Each hole for door locks, window winders, door handles, speaker holes are precision cut to fit ...
This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres ...
The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.
The boards that sit on the facia tray of cars built after 1970 as a base for the vinyl cover VGA1995
Earlier cars had a full panel metal tray and do not require these support boards.
The bracket fitted to the boot board and is not in any kits.
When a boot board is fitted the following brackets are required
14A9780x2 U shaped for the rear to hold the board
14A9781x2 side bracket with plug for board to si...
Called the rear bonnet seal it actually sits in the windscreen front scuttle panel on all minis up to 1991. This is the shape and size neoprene foam seal that we have found works best and has an adhesive backing to make fitting easier and less messy.
Roof gutter trim clip in stainless steel, ideal finishing item for our MT632 roof gutter trim.
Small angled bracket fitted by factory to stiffen front wings to A panels
Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)
Genuine Mini Spares product,with single hole jet, for fitting to windscreen scuttle panel with a round hole as original on cars from 1970 to 1980 or any car before the start of the "D" shaped hole in windscreen panel, which takes a GWW8010 jet.
...
Non return valve to fit end of washer pipe in bottle to stop sludge going up thin bore washer pipe tubing--and stop water to jets draining down,usually fitted to Winguard bottle and GWW506 valve was for original Tudor bottles.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.