WINDSCREN WASHER VALVE MK1/2/3 to 1975 WINGUARD TY...
GWW504

£1.50 exc vat

£1.80 inc vat

In stockIn stock
Non return valve to fit end of washer pipe in bottle to stop sludge going up thin bore washer pipe tubing--and stop water to jets draining down,usually fitted to Winguard bottle and GWW506 valve was for original Tudor bottles.

£1.50 exc vat

£1.80 inc vat

In stockIn stock

Recommended usage 1 x GWW504 to fit one mini.
Windscreen Washer - Qty 1

Recommended products
People also bought products

Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.

Sliding window catches chrome type for classic Mini MK1 & MK2, Traveller, Van, Countryman, Riley Elf and Wolseley Hornet.



Classic Minis and Mini Coopers had chrome metal catches for the sliding windows and channels. Black and white...

Complete car set of rear sliding window runners for Mini Estate and Countryman models.

Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Re-manufactured obsolete part now available to purchase. This is an item that often gets overlooked when rebuilding the doors. It accepts the screws that retain the nylon door guide dovetail. The drain tube also passes through it. Made from steel wit...

Complete set of R/H and L/H metal window frames for Mini Traveller, Countryman and estate models. All in part sections requiring assembly, with corner section inserts to reinforce 4 main strips, plus 8 fitting studs per side.

This is the onl...

Stainless steel stud for original production factory fitted sports pack arches.

These use FN105047 nuts.

New genuine arches now have an upgraded threaded brass insert and now use a stud ZUA000250.

Fluted type equivalent of GZF105A. This is equivalent

design of CZH4316 which was fitted between mini special black arches. Sold per side.

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5746SS AND1 x ALA5747SS plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complete door only.

Large blanking grommet for the Clubman inner wings, 1.5".

MkI aluminium boot lid "skin only" panel. This panel is produced off the original tooling, ensuring good panel fit and integrity. Following the pressing of the panel it is hand finished by Heritage craftsmen, to ensure the highest panel quality.