£3.00 exc vat
£3.60 inc vat
In stock
£3.00 exc vat
£3.60 inc vat
In stockRecommended usage 2 x CZH1720 to fit one mini.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
check strap arm in mild steel for the rear doors of countryman,estate and van.
Non Genuine only and only sold as a pair. Genuine were made obsolete early 90's
Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.
Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
10" blade MK1/2 with 6 sided nut for R/H/D or L/H/D with original 6 sided nuts. Right hand park, but you will have to disgard the nuts if you seek originality as after 1970 they became 8 sided or order correct kit for later type cars MSSK0...
Protective wax Rover introduced to protect newly drilled holes in bodywork for such things as Badges. A small 10ml sachet only but ideal for any new holes drilled for wiring,screws and badges where metal could be left bare.
Thses were suppli...
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.
Body side rear lower w/arch to rear section of bodyside repair R/H. 220mm tall.
Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.
Non genuine R/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a complete inner sill replacement panel. With carpet fix brackets.
Wiper mounting kit for Mk1 Mini's (3 required per car). Each kit comes with a pin, nut, 2 washers and mounting rubber.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.