Plastic clip for sunvisor 1964-5 and some bonnet props on early cars,was GHF1120 and ADA4370. the side clip on these models was ADA4484.

this set up was used with first plastic mirrrors and black rubber...

Black rubber bung to hold the bonnet prop in place on MK1/2 minis.

Also the same profile and shape as the rear boot board buffers but nearly twice the length at 1.5"(38.3mm).

This is the hook part with a spring and spacer only. This fits all Minis and Clubmans as the bracket it attaches to is on all bonnets unless broken. The spring loaded catch is designed to keep the bonnet from blowing open while driving should the lat...

This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. Original light colour Tan leather

3.3mm thick from the tanneries for use on horse bridles, with alloy fastening. Screws ...

All twin point injected minis were fitted with an in-cabin cable release for the bonnet lock and this later type had a plastic insert for the bonnet pin to travel through. This is part of a complete kit we have for any minis, see GS130273

The metal clip that holds the bonnet prop to the bonnet.

This is the metal clip that actually holds the prop to the bonnet at the front

edge.

CUP, BONNET LOCK

Standard mini bonnet spring for thimble on front is 2.5"long new and 15/16" wide

and will not fit the clubman bonnet which is 1.5"wide and 3.25" long

This is the Clevis pin for the hook part with a spring and spacer only. This fits all Minis and Clubmans as the bracket it attaches to is on all bonnets unless broken. The spring loaded catch is designed to keep the bonnet from blowing open while dri...