Non genuine chrome fluted trim - a silver version of the genuine GZF105A. They are hard enough to fit anyway but warming them up slowly to get supple is the best answer. Using a hairdrier on the sharp bends of the bodywork helps get the correct shape...

Upper door moulding rivet for Cooper S door trim. For Mk1 usually 1 at front and 3 at back making 4 per side and on Mk2 there were 2 per end at bottom making 4 per side. This is the 10mm head rivet and not required on our own 14A9773/9774 trims that ...

Fluted type equivalent of GZF105A. This is equivalent

design of CZH4316 which was fitted between mini special black arches. Sold per side.

Wiper mounting kit for Mk1 Mini's (3 required per car). Each kit comes with a pin, nut, 2 washers and mounting rubber.

Curley fibre glass Mini Miglia wheel arches, approximately 4.8." wide, with front edge 6.9" at widest point. Requires MS127FK brackets. Probably the largest wheel arches used on minis. Please note these are white gel coat not black and w...

Original shape washer jet for Mk1/2 minis. Made to the same specification as the last type made for rover parts sales with a nut on a loose thread so it can be tightened easily by hand in the engine bay without any modifications. Should be used with ...

This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. A copy of our Tan leather strap, but now available in black.

3.3mm thick from the tanneries for use on horse bridles,wit...

Minispares 2 piece plastic roof moulding kit specially shaped for the corners and drain holes as fitted from 1980on in black.

The 2 joining and finishing clips are DBE10006PMD which need to be ordered seperately. The last Rover...

Fixing stud for latest new type genuine Sportspack arches. (Five required per arch)

The scrivet for holding the front of the rear wheel Sportspack arch and the rear of the front arch. Rover also used rivet RY612535 as an alternative.

In 1993 the moulding between the wheel arches was changed from black plastic to rubber and was still used on twin point rubber arches. This is the Minispares version which is a slightly more rounded profile.