For 7.5 gallon petrol tank cars this is 29" wide with one corner cut. If you are looking for an alternative to this carpet covered wood boot floor, try our plastic load liner EBF100150

The bracket fitted to the boot board and is not in any kits.

When a boot board is fitted the following brackets are required

14A9780x2 U shaped for the rear to hold the board

14A9781x2 side bracket with plug for board to si...

The special pointed shape buffer locates against the boot board of Cooper S and variants where a factory type boot board is fitted.

bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted

Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.

Taller centre boot board bracket for when wider 165 tyres are fitted to the spare wheel. Supplied with the rubber and pin.

This very heavy duty bonnet strap is a excellent reproduction of the original factory Special Tuning department special. A copy of our Tan leather strap, but now available in black.

3.3mm thick from the tanneries for use on horse bridles,wit...

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

Threaded boss that fits in the floor of MK1 minis for the spare wheel clamp 14A6511 to screw into.

Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)

A complete set of 2 front door and one boot handle in chrome all with the same key numbers for wind up window door minis 1970on (keys included).

Door Handle Gasket's should also be replaced at same time, CZH1729 and [link]ALA579...

This kit contains all the brackets and mounts that were fitted on to the floor on original Coopers, Wolseley Hornet and Riley Elf with boot boards fitted as standard.

This kit does not include the bracket on the boot board 14A9783

These gaskets should be changed when replacing the hinges-this one goes between the bootlid hinge on the bootlid. See also 24A2176 for gasket on body.

These chrome spring type clips are used to keep the bonnet and boot from coming open on competition cars and are available in black. Holes will be required in the fitting of these so if you do not want to drill your body panels these are not for you....