When a boot board is fitted the following brackets are required:

14A9780 x 2 U shaped for the rear to hold the board.

14A9781 x 2 side bracket with plug for board to sit on except elf/hornet.

[link...

The bracket fitted to the boot board and is not in any kits.

When a boot board is fitted the following brackets are required

14A9780x2 U shaped for the rear to hold the board

14A9781x2 side bracket with plug for board to si...

This kit contains all the brackets and mounts required for fitting Minis with 10" 165 tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres see CCC115

For use with boo...

bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted

For 7.5 gallon petrol tank cars this is 29" wide with one corner cut. If you are looking for an alternative to this carpet covered wood boot floor, try our plastic load liner EBF100150

Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.

Threaded boss that fits in the floor of MK1 minis for the spare wheel clamp 14A6511 to screw into.

MK1/2 interior door handle with screw and washer.

This solid "spoon" handle is brittle and easily broken.

These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...

These gaskets should be changed when replacing the hinges, this one goes between the bootlid hinge on the body, see 24A2175 also for upper on bootlid.

Bootlid seal for Mini <91. Held in place on the boot lid using 26 clips(part# 14A6585).When fitting, the lip part of the seal open end for clips should face the inner boot catch- (the open end of the seal facing inwards to the bootlid al...

Seal for door handles MK1/2 and all sliding window exterior hinge cars.

also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate



is oval shaped



for boot / rear door use the hole at the rear ...

These are the little 'whisker clips' that hold the 14A9907 bezel on the front of the oval 3-instrument gauge pod 24A2702. The 'ears' slot into the back of the bezel and the tails that stick out go thru one of 14 holes in the...

This polished aluminium corner plate fits over the leading edge of the MKI/II door pocket to add protection and class. Only the Nearside plate is supplied.