Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5

Also used for 24A1169 glove box moulding MK1/2.

The chrome moulding to fit the door bin on all sliding type window doors, MK1/2 and all vans/pickups. See 14A6879 for early cars with lug ends held on by screws

Use the correct single sided prong clips only ADH3809 ...

These panels hold the door panels in place under tension inside the door aperture. It is not essential, but well worth replacing or renewing these in conjunction with new door panels. Sold in pairs.

MK1/2 interior door handle with screw and washer.

This solid "spoon" handle is brittle and easily broken.

These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...

Original type MK1/2 door strap in Dark grey(darker than cumulus grey and dove grey was slightly lighter again)

Check straps matched seat colours or outer main seat colour on two tone types

ALE1221 Black

[link]1...

Original type MK1/2 door strap in red

Check straps matched seat colours or outer main seat colour on two tone types

ALE1221 Black

14E8403 Cumulus grey-light grey-darker than Dove Grey trim

Original type MK1/2 door strap in green

Check straps matched seat colours or outer main seat colour on two tone types

ALE1221 Black

14E8403 Cumulus grey-light grey-darker than Dove Grey trim
<...

This plastic handle fitted any wind up window cars up to the introduction of the twin points, which then changed and the handle fitted from 1996 on is now obsolete.

plastic bezel that sits behind window winder handle.

Mk1 1962 on grey headlining that fitted on 2 hoop type frames whereas the Mk3 had individual rods. This is for Mk1 saloons only, see 5D4085 for cream crackle. (Does not include the framework).

Black door pocket liner for the L/H door which has sliding windows and external hinges

L/H BOOT BOARD BRACKET FOR 7.5 GALLON TANK AND 165 TYRES.