These panels hold the interior door panel in place against the external door skin by bearing against the internal door frame. A pair of fillet panels will fit one door, one at the front of the pocket and one at the rear, so two pairs will be needed f...

Door panels in Red for MK1/2 doors less the fillets. This door panel design was used on all saloons & travellers from 1959 until 1970 when the door itself was redesigned. The panel slides into the door aperture and is held in place with a pair of doo...

MK1/2 interior door handle with screw and washer.

This solid "spoon" handle is brittle and easily broken.

These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...

Fitted on cars up to about 1982 approximately before spring type knob on handle was introduced for safety homologation YXX3199PA.

The screw this CZA7109 handle is ZKC3317.

Original type MK1/2 door strap in green

Check straps matched seat colours or outer main seat colour on two tone types

ALE1221 Black

14E8403 Cumulus grey-light grey-darker than Dove Grey trim
<...

door opening pair of handles in Burr walnut to compliment the wooden dashes

See also MSA0192 door pull handles, MSA0191 door cappings and MSA0194 window winder handles. Use SE910161 screw.

Mini Pickups had a one piece headlining frame with the canopy glued and stapled to it. Cream Crackle was used on early models and the light grey was used during the 1970's. These frames are no longer available, so make sure you keep the frame safe if...

Black door pocket liner for the L/H door which has sliding windows and external hinges

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.