£49.22 exc vat
£59.06 inc vat
In stock
£49.22 exc vat
£59.06 inc vat
In stockRecommended usage 1 x DP3046A to fit one mini.
Reinforced elastomer liner for door trim made from VELVEX to prolong the life of your door cards.Die cut on press tools that make the original door cards. Each hole for door locks, window winders, door handles, speaker holes are precision cut to fit ...
These panels hold the interior door panel in place against the external door skin by bearing against the internal door frame. A pair of fillet panels will fit one door, one at the front of the pocket and one at the rear, so two pairs will be needed f...
These panels hold the door panels in place under tension inside the door aperture. It is not essential, but well worth replacing or renewing these in conjunction with new door panels. Sold in pairs.
Black door pocket liner for the R/H door which has sliding windows and external hinges
Black door pocket liner for the L/H door which has sliding windows and external hinges
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
Even if you have not just restored your car- you don't want the door to fly open uncontrolled. Not only can it damage the hinges but also the paint job.
Check straps matched seat colours or outer main seat colour on two tone types
(...
This is the top of the range spray glue that is used to make all our trim products. We recommend you use spray glue to fit your trim products to your car (where applicable). You can use the glue to fit underfelt and carpets to your floor pan, your fo...
Plastic window locks for sliding windows, metal ones are no longer available.
24A1194 = Right Front
24A1195 = Left Front
24A1196 = Right Rear
24A1197 = Left Rear
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
Fire retardent felt with correct cut outs for MK3 cars for the mini firewall just behind the carb and air cleaner full width of the panel see FELT860 for spray adhesive.
These alloy/aluminium 'polka-dot' kick strip plates were originally fitted to the MKI Mini to protect the door seals and to hold them against the body.
The rubber sucker that sits on one prong of the internal mirror to secure it against the windscreen to stop vibration and movement. Fitted from 1965 until design change in 1996. A black sucker 24A1535 was fitted on a twin ball stem from ...
Deluxe black carpet set for post 1973 vans and pickups with the later square tunnel and rod change gearbox. Comes pre moulded for an exact fit with sound deadening already attached. Rod change. 4 week delivery if not in stock
These have no r...
Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5
Also used for 24A1169 glove box moulding MK1/2.
Four tailor made felt pieces to fit in the segments between the bonnet strengthening webs to allow maximum under bonnet clearance.
See FELT860 for spray adhesive. These are about 1cm thick and the original very thick sound dea...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.