£12.50 exc vat
£15.00 inc vat
In stock
Use the correct single sided prong clips only ADH3809 as other
clips usually cause damage
£12.50 exc vat
£15.00 inc vat
In stockRecommended usage 2 x 24A1169 to fit one mini.
Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5
Also used for 24A1169 glove box moulding MK1/2.
The chrome moulding to fit the door bin on first 80 thousand MK1 minis with extra length tag with screw hole for location.
This is held on by screws but a single sided prong clips ADH3809 can be used in the centre - beware other...
These panels hold the interior door panel in place against the external door skin by bearing against the internal door frame. A pair of fillet panels will fit one door, one at the front of the pocket and one at the rear, so two pairs will be needed f...
The chrome moulding to fit the door bin on first 80 thousand MK1 minis with extra length tag with screw hole for location.
This is held on by screws but a single sided prong clips ADH3809 can be used in the centre - beware other...
These panels hold the door panels in place under tension inside the door aperture. It is not essential, but well worth replacing or renewing these in conjunction with new door panels. Sold in pairs.
High quality, polished alloy door pull handles.
These aluminum handles will wind up window cars and they won't snap off like the original plastic ones
For matching window winders see MSA1130.
See MSA1129 for...
MK1/2 interior door handle with screw and washer.
This solid "spoon" handle is brittle and easily broken.
These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
Original type MK1/2 door strap in Dark grey(darker than cumulus grey and dove grey was slightly lighter again)
Check straps matched seat colours or outer main seat colour on two tone types
ALE1221 Black
[link]1...
This 10 piece handle set is exactly the same kit as sold by every other mini specialist is in bright alloy (not polished alloy as per our other superior kit MSA1129) and consists of two of each of the following, door openers, window winders and their...
This plastic handle fitted any wind up window cars up to the introduction of the twin points, which then changed and the handle fitted from 1996 on is now obsolete.
If you drive your MINI/MGB often then you know that the standard plastic window winder handles are prone to breaking. These chrome metal handles are somewhat stronger and look great alongside the other chrome trim in the car's interior. Next time ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.