£9.45 exc vat
£11.34 inc vat
In stock
£9.45 exc vat
£11.34 inc vat
In stockRecommended usage 1 x CZH3241 to fit one mini.
Threaded boss that fits in the floor of MK1 minis for the spare wheel clamp 14A6511 to screw into.
MKI boot lid manufactured by British Motor Heritage. Always fix your swinging number plate and hinges on for dummy fit and alignment before spraying.
The double skin Mk1/2 type 8G9270 introduced in december 1966 is only availabl...
Non Genuine metal battery box. always going rusty owing to the location of where it is fitted. Requires welding in place and preferably painted or a protective coat. Remember to check if the battery cover, strap and clips need changing. Popular afte...
The boot floor (trunk of the Mini) has always been an area with a great potential to rust. Not only is it often exposed to battery acid but typically water collects there and rust results. BM Heritage produce a sub assembly from original tooling tha...
Genuine metal battery box. always going rusty owing to the location of where they are fitted. Requires welding in place and preferably painted or protective coat of some kind and remember to check if the battery cover, strap and clips need changing...
The genuine bootlid fitted from 1988 where the seal sits on the car body rather than the bootlid itself. The only difference between this and the earlier BMP339 is that it does not have holes drilled for the boot seal clips.
Non genuine mini boot lid with full skin inner frame. The genuine alternative to this is BMP339 with an open back.
Key barrel set for Mk3 onwards door handles and boot handles.
This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.
The boot board bracket 14A9783 is not included
For 10" wheels with 145 tyres ...
bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Round spare wheel clamp with bolt for fitting in the boot to the spare wheel boss as fitted to Mk1 minis. See 88G479 for the boot floor boss that this clamp screws into.
Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)
If you want to hold it in place then this is easy and simple. 4" long rubber hooks can be used on bonnet and/or boot lid. Packaged in pairs with both brackets.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.