£0.21 exc vat
£0.25 inc vat
In stock
£0.21 exc vat
£0.25 inc vat
In stockRecommended usage 1 x DJP8800 to fit one mini.
Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...
30 amp maximum fuse for the engine fusebox and management link under the bonnet.
blade or double spade type fuse
Maxi fuse located in the engine bay fusebox on all post 1997 mpi cars, 30amp.
Maxi fuse located in the engine bay fusebox on all post 1997 mpi cars, 30amp.
Inline fuse holder with approximately 7" of wire to replace the old original holders located under the scuttle panel which corrode over time.
30 amp maximum fuse for the engine fusebox and management link under the bonnet.
blade or double spade type fuse
Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.
Complete fuse box less fuses is RTC440A.
Fuse Box-Pre 1976
Early style twin fuse box as used on many cars and models. If your box is corroded, as most are, then the "Price of Darkness" is bound to strike you.
This is the 'later' early model with blade connectors and comes...
Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.
If you don't remember where your spares are, or you've used them up, you may want to replenish you...
Both personal safety and many sanctioning organizations require the use of switch for easy and complete cutoff of power from your battery. Easy to install and even provides a fused ancillary connection.
The most common use of this "great id...
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Set of 4 ignition leads from the original supplier to Unipart, suitbale for all twin point minis 1997 onwards
Range of distributors with modern day curves specially built,programmed and tested for Mini Spares in UK.
Beware of the cheap China made units that we have tested and currently offered by other vendors that are poorly made with wrong setting...
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.