RELAY FOR ENGINE MANAGEMENT SINGLE POINT ONLY
YWB10022

£136.00 exc vat

£163.20 inc vat

In stockIn stock

£136.00 exc vat

£163.20 inc vat

In stockIn stock

Recommended usage 1 x YWB10022 to fit one mini.
Flasher Unit, fusebox and relays - Qty 1

People also bought products

This is the hazard switch repair plug for post 1976 rocker switches, pins supplied so you can wire accordingly.

Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.

Originally fitted as standard to the MGB and MGB GT, but has the same plug configuration as the 76 on Mini's so can be used in place of the stabdard rocker switch

If you also have an issue with the plug, a new plug and wiring repair is avail...

Inline fuse holder with approximately 7" of wire to replace the old original holders located under the scuttle panel which corrode over time.

Repair loom and plug for all post 1976 headlamp switches.See PM08 for headlamp switch with plug and correct wires colours for loom repair

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

30 amp maximum fuse for the engine fusebox and management link under the bonnet.

blade or double spade type fuse

Used on the following circuits: Heater blower motor, driving light relay, sunroof motor, wipers/washers, radiator cooling fan, indicators, stop-lights, reversing lights, heated rear window and front foglight relay.

Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...

Genuine Mini Spares product, fits 3 and 4-synchro gearboxes except for rod change types which use GAE191. This switch replaces the plug on the front of the remote-shift transmission case. It is triggered internally by the shift linkage w...

Special flat 3/8" UNC nut for the reverse light switch GAE191.

Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.

Fitted under the bonnet on top of the servo. Relay for the engine management on twin point cars only from 1996-except for cars with air conditioning which use YWB101080.

A cable/ switch under the pedal on Single point injection cars.

Metal plate switch carrier for 5 square type switches.

Correct 42watt 12 volt Indicator flasher unit for all MK1 minis easily identified by the locating tag on its end it was the longest/largest flasher ever fitted to the mini.





please note. this unit only works with NEGATIVE ...

If you have a floor mounted type of headlamp dip switch then this is the item you require.Mk1 Mini--sprite/midget MGB67-70,morris Minor.landrover,bentley, rolls and many more.

This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...

You should always use this kit for fitting any auxiliary spot or fog lamps.

Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.

Please note, SPI and MPI cars have this facility built as standard safety ...