SCREW NUMBER PLATE LENS TO LAMP BODY MK3 ONWARDS
PMZ206

£0.22 exc vat

£0.26 inc vat

In stockIn stock
Screw for holding PRC1230A to the number plate light body, 1970 onwards.

£0.22 exc vat

£0.26 inc vat

In stockIn stock

Recommended usage 4 x PMZ206 to fit one mini.

People also bought products

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

LED side repeater lamp for all 1986 on cars. No resisitor required

This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).

Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.

Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.

This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.

Interior lamp with square blunt ends. This part superseded 13H192 which originally had the black on/off switch which BMC also fitted as an alternative. Fitted from October 1964 when courtesy light switches were introduced on Cooper from body number 3...

INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car

INDICATOR LAMP WITH ORANGE LENS AND LED BULBS. Sold singly, 2 required per car

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.

A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.

Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models

Auxilary wiring for genuine Rover spot and fog lamps needed when fitting genuine lamps to cars not originally fitted with auxilary lamps or for cars that have had the wiring damaged. This loom is supplied with complete lamps XBN10008 and...

Interior lamp (dome lamp) lens. Fitted from 1959 to 1974 (mk 1 2 3).

Fits our 14A9148 and 13H4398 lamps

Genuine Mini Spares L/H lamp with white lenses. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp.

Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper ...

Genuine Mini Spares R/H genuine lamp with white lens. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp. Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper lens...

THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.

3 per lamp required or 6 per car set.