Trim clip for fitting the stainless/rubber window moulding (EJU10003) on to the door. Sold individually.
Not every Mini has hinged rear quarter windows (rear side windows). This is the seal for the ones that don't open. The original rubber is prone to being very baked by the sun and thus dry out and crack. The other problem comes from people that have...
Genuine Mini Spares product.Quarter window seals for non-piano hinge type pop out rear side windows as fitted to Mk3.
Plenty of imported copies on the market but this is our true UK copy of the original as made by Standard Products for Rove...
Draft excluder for sliding window doors as fitted to Mk1/2 Minis and vans.
Left hand side..Either crimp both ends with your fingers to make it stay on door glass or use a glue as per the factory on later vans. QTY one per door. Angled cut a...
Vertical fitting double row channel for sliding windows on the rear of mini traveller and estate rear windows.
Vertical fitting double row channel for sliding windows on the front of mini traveller and estate rear windows
Seal for glass that fits both rear doors on vans/estates. The reason for changing these every few years is that if they leak the water runs into the doors causing excessive rust.
Upper double row channel for the rear sliding windows on clubman estates
The plastic chrome insert for fitting in the windscreen and backlight rubbers of all minis. You will require TOOL02 to fit these.
Sliding window type weatherstrip kit L/H.
Kit contains lower and upper sliding channels plus the vertical strip that attaches to the glass as a draught excluder plus the stainless steel window catch runner that the lower channel sits in,with...
Genuine Mini Spares mouldings product as supplied to Rover.
For wind up window cars 1970 on this is a set of inner and outer door brightwork mouldings with rubber seals attached to stop water running down the windows causing rust and to prev...
Genuine Mini Spares quality product. For Mk1 cars use 14A8744
For Pickups you will need to cut and shorten either seal and make sure the join is at the bottom. The extrusion is the correct shape.
This seal is the best ...
Draft excluder for sliding window doors as fitted to Mk1/2 Minis. Right hand side. Properly cut angles as original.Either crimp both ends with your fingers to make it stay on door glass or use a glue as per the factory on later vans.
Qty one...
The MK1/MK2 Mini not only has a smaller rear side quarter window than the MK3 but also the rubber seal is cosmetically different. The only seal available for years was the MK3 which has a grain texture on the inside edge. Now in stock are very good r...
Finishing clip in brightwork (chrome colour)for 24A1466MS locking strip in windscreen and backlight rubbers.
Fitted from late 1992 and on all MPI cars 1996 on it has an extra lip to give a neater seal line to help quieten down windscreen/panel vibration noise on the "drive by" homologation tests.
Also designed to help stop windscreens from leaking ...
Most minis have a chrome coloured plastic insert in the windscreen rubber but
some owners in hot countries prefer this black one, which some claim is less prone to shrink or go off colour.
Rubber seal for all mini windshields. Uses locking strip 24A1466(chrome) or 37H8052(black.) REMEMBER YOU MUST FIT THE RUBBER TO THE BODY FIRST. DO NOT USE THE STRING METHOD BECAUSE IT STRETCHES AND TEARS THE RUBBER.
There is a later wider r...
All mini windscreen and backlights have this plastic moulding in the middle 99% of the time. Chrome in colour, this is on a 30metre roll for trade use.
PW5013 is the black equivalent.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.