Moulded carpet set for all Minis Estates built after May 1973. The gear box linkage mechanism was changed the to a rod system which included a redesign of the gear box tunnel in the front floor area. These new sets have truly moulded front and rear s...
Moulded carpet set for all Minis Estates built after May 1973. The gear box linkage mechanism was changed the to a rod system which included a redesign of the gear box tunnel in the front floor area. These new sets have truly moulded front and rear s...
This Biscuit carpet is the correct moulded shape with insualation material attached where appropiate for that smart fit over the gearbox tunnels etc.For vehicles pre 1972 with remote or magic wand type gear levers you will therefore have to cut this ...
Reproduction of the original type fireproof bulkhead sound-proofing foam insulation. These often detiriorate overtime and turn into a crumbly mess.
These are pre-cut for the mounting points and accessories that are on the bulkhead...
Reproduction of the original type fireproof bulkhead sound-proofing foam insulation. These often detiriorate overtime and turn into a crumbly mess.
These are pre-cut for the mounting points and accessories that are on the bulkhead...
Mk1 1962 on black headling that fitted on 2 hoop type frames whereas the Mk3 had individual rods. This is for Mk1 saloons only, see 5D4085 for cream crackle. (Does not include the framework).
Kit of four plastic carpet protectors for where the seat frame runs. Two are flat and two are shaped to help with the shape of the tunnel. This kit includes the securing rivets. Ideal if your carpet is in good condition but the plastic plates have de...
Curley carbon fibre race dashboard and speedo pod, these are intended for race car fitment and will need trimming/brackets making to fit etc.
Non moulded navy carpet set for vehicles pre 1973 with remote or magic wand type gear levers, you will therefore have to cut this hole out. Handbrake hole is ready cut with an over trimming gaiter (not the original rubber type) in place for tidier lo...
Cream crackle with mirror and one arm, uses GFK7344 clip on one end, fitted from Oct 1964 to 1965, right hand mirror for left hand drive. Or drivers side on r/h/d
Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...
Headlining kit for MPI cars, this is grey cloth as apposed to vinyl (much nicer in our opinion). Rear C post panels included.
Seat front base foam replacement. Moulded foam base and only one available solely from us, has been used on 1993 to 2000 cars. Made from sample from Rover of HGA100840
Horn push assembly for the Mk1 Mini, Mk1 Mini Cooper and Mk1 Mini Cooper S.
PLEASE NOTE: This assembly does NOT include the centre emblem.
For the complete assembly including the centre emblem, see 27H6943 and [link]2...
This set will fit all Travellers and Estates built between 1966 until 1980. The kit contains a piece of carpet to fit the rear of the back seat and another piece to cover the rear floor area. For the earlier 4 piece kit pre 1996 with external tank se...
Door panels in dove grey for MK1/2 doors less the fillets. This door panel design was used on all saloons & travellers from 1959 until 1970 when the door itself was redesigned. The panel slides into the door aperture and is held in place with a pair ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.