($0.65) £0.65 exc vat
($0.78) £0.78 inc vat
($0.65) £0.65 exc vat
($0.78) £0.78 inc vat
Recommended usage 1 x ADU4278 to fit one mini.
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
For wipac quadoptics-replacement bulb holder for lamps also supplied in kit.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. The halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives g...
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
TWin point and overseas cars were fitted with headlamps that self-level for when carrying loads. This is the motor in the headlights.
These are for Left had drive L/H/D. See S4698B for Right hand drive R/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special...
These are R/H/Drive, see S4699B for L/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives good long range visi...
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
This is the complete lamp including the self level motor with plastic backing bowl as fitted to late injection cars and German/Japan spec vehicles (will require wiring)
L/H/D Headlight unit to accept separate main beam bulb and auxiliary bulb. Uses GLB410 bulb. Sold singly 2 required per car.
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
Single replacement unit for the right hand drive kit S4698B with left hand dip
lamp part only, does not include the rubber cover, bulb or side light part
Fitted to twin point injection cars and a few single point (mostly export)with self levelling function complete less headlamp rim--See 500929ms in stainless steel for rim or 17H5143 for chrome over brass. Comes complete with foam seal. I...
LED side repeater lamp for all 1986 on cars. No resisitor required
Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.