($3.25) £3.25 exc vat
($3.90) £3.90 inc vat
Out of stock
($3.25) £3.25 exc vat
($3.90) £3.90 inc vat
Out of stock
Non genuine water pump gasket for all A series engines.
By pass hose plug. Frequently rusted on old heads and not even there on newer heads. These are 5/8" x 16tpi "whitworth fine" thread.
Very useful for head changes where by pass hose is not required.
This gasket fits on the cylinder head for every A series heater valve or outlet pipe until the hole was no longer drilled when they changed to a heater valve fitted into the hose line from 1990 on.
True Kevlar strands with 2 year guarantee.Fitted as standard in some of the hot countries before heaters became standard fitment this hose has the elbow joint missing that connected to the half inch heater hose. A favourite for racers and competion e...
Block to filter head gasket when spin on type filter is used (except billet types which use 88G402). The black side goes against the engine and the red against the filter. This also has a sealant strip on it to help stop leaks.
1275cc engine top hose in Rubber with Kevlar reinforcement.
Kevlar is a high tech aramid fibre produced by Dupont co in USA.
It is longer lasting, stronger with less heat transfer and wear resistance.
Not only does this hos...
This is the metal plate to blank off the mechanical pump hole on the engine block. No longer available from Rover but Mini Spares have them.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.