($37.50) £37.50 exc vat
($45.00) £45.00 inc vat
In stock
($37.50) £37.50 exc vat
($45.00) £45.00 inc vat
In stockRecommended usage 2 x RLH101070 to fit one mini.
Rear hub nuts on the mini are sided as the threads are different. This is for the right hand rear and is usual right hand thread to tighten.
See FNN2410 for left hand nut.
Fits the rear hub of every Mini to protect the bearings grease from debris, but
this metal cap always seems to get damaged on 10" wheel cars or when you change the bearings - make sure yours are in place.
Rear hub nuts on the mini are sided as the threads are different. This is for the LEFT hand rear. This has a left handed thread.
See NL611041 for the right hand nut.
This is the correct length for all minis using the rear spacered type drum which was fitted to all Cooper "S" 1275GT and every mini from 1984 to 1996 except the ERA Turbo and Sportspac cars which had 13" wheels. Stud shank length from under head of b...
As fitted to MPI from 1996 on with an extra O ring. The O ring goes between the first bearing and backplate on stub axle. Rear tapered roller wheel bearing kit, for one wheel.
All post 1985 cars and the Mini Cooper S were equipped with very...
Rear tapered roller wheel bearing kit, for one wheel. Not genuine Timken type but a copy. These can be used on any Mini. Kit includes inner and outer bearings with spacer plus seals and split pin. If you are into preventative maintenance, then the ta...
Mini Spares product from own original tooling since 1989.This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the R/H rear radius/trailing arm.
This shroud uses 14A7091 rubber plug not suppl...
Mini Spares product from own original tooling since 1989.
This small sheet metal panel mounts below the horizontal seam, covering the pivot pin of the rear L/H radius arm. Was unavailable for many years.
This shroud uses [link]14A7...
Mini Spares product,metal trunnion to hold the 2-2A5818MS bushes on the rear subframe.
Originally there were 4 of these trunnions on the subframe but in 1976 (MK4)the front 2 brackets were strenghened and enlarged to [link]21A2...
Mini spares product.In 1976 Rover started fitting this larger metal trunnion to the front of the rear subframe which only used one single large bush 21A2560.
2 required per car but sold singly
The Mini's rear subframe is rubber mounted. Polyurethane (stiffer, much longer lasting) bushes are now available for the rear subframe trunions. Cars manufactured before 1976 can use the same bush (2A5818/POLY) at the front and rear of the subframe, ...
The Mini's rear subframe is rubber mounted. Polyurethane (stiffer, much longer lasting) bushes are now available for the rear subframe trunions. Cars manufactured before 1976 used the same bush 2A5818(C-STR638) at the front and rear of the subframe, ...
This bolt is not likely to break, but very prone to rust. (Washer not included).
fitted from 1976 on rubber mounted subframes this washer goes on the large single tower bolt on the front subframe---fits on top of the standard original rubber seal KGE100050 to stop damage
Dry version should be used if converting from "wet" to "dry". Left side.
Dry version should be used if converting from "wet" to "dry". Right side.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.