Also see kits MSSK017 and MSSK017B

Left hand top hinge -wind up window type minis from 1970 on-- note -the studs actualy thread into the genuine hinge and can be replaced with a bolt if damaged or broken

These shims are what the factory used to fit on the other side of the hinge panel as a stiffener and sometimes even to align the doors themselves, 2.2mm thick.

Special thread cutting screw 1/4 UNF 1.25" (31mm) long.

Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...

Mk3 Mini onwards door frame assembly without the door skin L/H

Supplied unpainted ready for door skin fitment.

Non genuine R/H repair section

for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...

Genuine R/H door without crash bar which only later cars had fitted. This door also has no hinges.R/H Door framework only is available as MSP020 The later type door with the crash safety bar fitted internally are available as [lin...

The MKI Mini door is distinctive with its external door hinges and inside pocket and sliding windows. The single biggest problem with the doors is the tendency to rust particularly along the bottom edge. Make sure you fit new drainage hoses [link]14...

Genuine Mini Spares mouldings product as supplied to Rover parts division.

L/H outer brightwork trim with the seal attached to stop water seeping down into the door frame, on all cars with wind up windows from about 1980 on, these are the la...

Right hand rear door for the clubman and mini estate as well as the van. These are from original tooling. The seal for the window is 14A7210 and if you want to grab the last of the rear window glass at sale prices see 14A7181

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Door hinge shim for all wind up window cars, these are used to align the doors, 0.7mm thick and made in stainless steel, use with ALA6382 to get good door alignment. See ALA6381 for thicker rear support plate.

Key barrel set for Mk3 onwards door handles and boot handles.

Clip for Door Handle required when changing barrel set. Heavy duty round spire clip specially made for the job.

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5745 KIT with the 2 rails which are different front an rear (ALA5746 and 5747) plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complet...