TIMKEN BEARING PAIR ONLY FOR IDLER GEARS
C-JKT1000

(114,66 €) £114.66 exc vat

(137,59 €) £137.59 inc vat

In stockIn stock
these are the special bearings as fitted to original Jack Knight and original evolution idler gear conversion.

available as a pair only for rebuilding our timken idler kit.

LL52549 and outer case LL52510

(114,66 €) £114.66 exc vat

(137,59 €) £137.59 inc vat

In stockIn stock

Recommended usage x C-JKT1000 to fit one mini.

Kit products
IDLER GEAR TIMKEN CONVERSION PRE A+ STRAIGHT CUT
C-STR30T

The ultimate idler gear conversion for straight cut drop gearsets only. This set up is for Pre A plus idler gearbox cases only and uses timken roller bearings either end.





Achievable drop gear ratios when using our Evol...

(122,00 €) £122.00 exc vat

(146,40 €) £146.40 inc vat
IDLER GEAR CONVERSION A PLUS STRAIGHT CUT
C-STR30TA

The ultimate idler gear conversion for straight cut drop gearsets only.This set up is for A plus idler gearbox cases only and uses timken roller bearings either end.





Achievable drop gear ratios when using our Evolutio...

(122,00 €) £122.00 exc vat

(146,40 €) £146.40 inc vat
People also bought products
OUTPUT SHAFT COLLETT
88G493

Only fitted to vehicles with hardy spicer output shafts (Cooper S and autos). Two collets are fitted in the output shaft in the gearbox and located behind the rubber seal 22A1566

(5,75 €) £5.75 exc vat

(6,90 €) £6.90 inc vat
CIRCLIP 1ST MOTION NOSE OUTER CAGE
2A3643

this is the large clip that retains the outer track of AAU8424 bearingin your clutch case for the roller bearing that sits on the end of the 1st motion shaft. The little circlip that holds the bearing on the shaft is CCN110

(3,50 €) £3.50 exc vat

(4,20 €) £4.20 inc vat