(46,50 €) £46.50 exc vat
(55,80 €) £55.80 inc vat
In stock
(46,50 €) £46.50 exc vat
(55,80 €) £55.80 inc vat
In stockRecommended usage 1 x CCC106 to fit one mini.
The classic Mini phone holder with USB replaces the existing ashtray in the padded dash rail.
Key Features:
Plate is made from powder coated 3mm steel
Spring loaded clamp, hold phones between 59mm to 106...
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
Classic Castrol oil can with flexible spout and thumb pump.
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
Reinforced elastomer liner for door trim made from VELVEX to prolong the life of your door cards.Die cut on press tools that make the original door cards. Each hole for door locks, window winders, door handles, speaker holes are precision cut to fit ...
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Wheel arch fitting kit for MS127 Mini Miglia arches.
Curley fibre glass Mini Miglia wheel arches, approximately 4.8." wide, with front edge 6.9" at widest point. Requires MS127FK brackets. Probably the largest wheel arches used on minis. Please note these are white gel coat not black and w...
The bracket fitted to the boot board and is not in any kits.
When a boot board is fitted the following brackets are required
14A9780x2 U shaped for the rear to hold the board
14A9781x2 side bracket with plug for board to si...
Called the rear bonnet seal it actually sits in the windscreen front scuttle panel on all minis up to 1991. This is the shape and size neoprene foam seal that we have found works best and has an adhesive backing to make fitting easier and less messy.
Roof gutter trim clip in stainless steel, ideal finishing item for our MT632 roof gutter trim.
Heavy duty 4 layer outdoor stormforce custom fitted car cover for your mini saloon or clubman, totally waterproof, vented and soft lined with under straps for ultimate weather protection.
CCC103 indoor/outdoor, saloon only
...
Original MK1/2 shape with correct 1.25" small neck.
Originally made by Winguard these plastic washer bottles for early Minis were often asked for but rarely available.
The original part number for the Winguard MK1 bottle was ADA383...
Roll pin punch for removing RPS1416 roll pin from the gear selector mechanism.
Factory fitted rivet for the mini special wheel arches, the plastic type fitted as standard from 1984 to cover 12" wheels.
16 required but beware of the front rivet on the rear wheel arch as it goes through a double skin. 5/32" TYPE 7/16" LO...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.