(52,65 €) £52.65 exc vat
(63,18 €) £63.18 inc vat
In stock
(52,65 €) £52.65 exc vat
(63,18 €) £63.18 inc vat
In stockRecommended usage 2 x XBS100140 to fit one mini.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
These are for Left had drive L/H/D. See S4698B for Right hand drive R/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special...
These are R/H/Drive, see S4699B for L/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives good long range visi...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
This is the complete lamp including the self level motor with plastic backing bowl as fitted to late injection cars and German/Japan spec vehicles (will require wiring)
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
Fitted to twin point injection cars and a few single point (mostly export)with self levelling function complete less headlamp rim--See 500929ms in stainless steel for rim or 17H5143 for chrome over brass. Comes complete with foam seal. I...
Screw for holding PRC1230A to the number plate light body, 1970 onwards.
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.
3 per lamp required or 6 per car set.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.