Metal CV gaitor ties for the outer CV gaitor, slim in design in order to give maximum clearance between CV and hub

Plain half thickness half inch nut as used on our C-AJJ3365 arms and steering rack adjustment nut for track rod ends.

Non genuine aftermarket only as the genuine originals are obsolete.

These are the best on the market where clip grooves are in the correct place to save the driveshaft seizing on. Later model Minis have CVs on both ends of the axle; this is ...

Originally made to go on the heater tap studs on the cylinder head these are 1/4" unf for any other use to brighten uo your car. If you want the whole anti corrosion set of nuts and studs for the heater tap see C-STR285.

A special 3/8" unf half nut (9/16"AF spanner size)for fitting on rear brake hoses and carbs to manifold.

Top quality nut unlike many sold with CV joints from china.

For genuine nut See BTA249 also. Sold singly

Special grease for Cv joints and any homokinetic joints. Enough for one joint only.

Genuine Rover Xparts item. See BHM7012 which many vendors sell as their GSV1073.

In board CV joint(pot joint)gaiter kit metal clips and grease.

The single largest reason for the failure of this rugged assembly is contam...