Minis leak oil-- full stop ,so when changing gaskets except for the cylinder head apply always apply hylomar or this RTV sealant which is great for sticking the gasket to the rocker cover and letting it dry before installation. Used by Rover on the d...

We all knows Mini's like to leak a little oil... This drip tray is great for protecting your garage floor, low profile and measures 60x40cm.



Perfect for using whilst rebuilding heads, engines and gearboxes to keep all the small pa...

Imperial & Metric spanner set ideal for completing most tasks on your classic Mini, these are mirror polished spanners.



Contents: Bi Hex x Metric combination spanners 6, 7, 8, 9, 10, 11, 12, 13, 14, 17, 19mm and Stubby 10, 11, 12, ...

3/8" 6 point shallow AF/Imperial Socket set



Sizes 3/8", 7/16", 1/2", 9/16", 5/8", 11/16", 3/4", 13/16"

Classic Castrol oil can with flexible spout and thumb pump.

CV fitting tool, designed to assist with the correct fitting of CV joints, wheel bearings or drive flanges, as specified in the Haynes workshop manual. The wheel bearing should be torqued to the specified setting using this washer, and then removed a...

ESPECIALLY FOR MINIS

This 20-50w semi synthetic oil is produced especially for minis where it needs to lubricate both engine and gearbox parts giving the neccessary coating and protection. Semi synthetic has a long life to 100c with maximum ...

Two part primary gear oil seal tool (known as clutch seal tool). It includes the sleeve that slides over the primary gear to protect the seal membrane on the gear splines, plus the outer body that pushes the seal home square. This is achieved by usin...

Inboard CV (pot joint) splitting tool used to remove the constant velocity joint from the gearbox by way of driving this wedge-like tool between joint and gearbox. Does not remove joint from driveshaft.

Minis leak oil-- full stop ,so when changing gaskets except for the cylinder head apply always apply hylomar or this RTV sealant which is great for sticking the gasket to the rocker cover and letting it dry before installation. Used by Rover on the d...

Crank pulley and camshaft nut socket also CV joint nut pre metric thread and subframe single tower mounting bolt on post 76 cars. Also fits pre 1997 steering wheel nut. 1/2" Drive.